Vue Chart - SplineAreaSeries.valueErrorBar
Error bars are used on charts to indicate an error or an uncertainty in a reported measurement. They give a general idea of how precise the measurement is.
Error bars can be generated either from concrete or calculated values. To generate one error bar, two values, high and low, are needed. If the chart data source supplies concrete high and low values, assign the required data source fields to the highValueField and lowValueField properties. To hide individual error bars, set the corresponding low and high values in the data source to null
.
Alternatively, error bar values can be calculated according to an algorithm. In this case, use the type property to choose a required algorithm, and use the value property to specify the value to be used in calculation.
color
This property supports the following colors:
- Hexadecimal colors
- RGB colors
- RGBA colors
- Predefined/cross-browser color names
- Predefined SVG colors
- Paint server address
edgeLength
A value in the range from 0 to 1 specifies the length relative to the point diameter (for circular series points) or width (for bars).
Any other value specifies the length in pixels.
type
Depending on the type of errors you need to visualize, use error bars of one of the following types.
type | Description |
---|---|
"percent" | Defines the confidential interval in percentages. Error bar values are calculated as a percentage of the series point value. The percentage value is determined by the value property. The high and low error bar values are drawn symmetrically up and down from the series point. |
"stdError" | For information on the standard error, refer to the article in Wikipedia. |
"stdDeviation" | For information on the standard deviation, refer to the article in Wikipedia. |
"variance" | For information on variance, refer to the article in Wikipedia. |
"fixed" | Defines the confidential interval in constant values. Error bar values are determined by the value property. The high and low error bar values are drawn symmetrically up and down from the series point. |
value
Depending on the value of the type property, the value property applies as follows.
type: 'percent'
The value property specifies the percentage of the series point value to be taken.type: 'stdError'
The value property multiplies the calculated standard error.type: 'stdDeviation'
The value property multiplies the calculated standard deviation.type: 'variance'
The value property multiplies the calculated variance.type: 'fixed'
The value property specifies constant error bar values.
If you have technical questions, please create a support ticket in the DevExpress Support Center.